check : check if all ok
checkzone : check if all zone are ok
exit : exit housecontrol server and let it relaunch auto
quit : quit the checker (it will auto relaunch) use when updated
Note: after quit, use quit again to prevent rerun, another command for autorerun
ignore : do nothing
stop : exit server and pause the checker so no relauch
kill : force stop of server but let it relauch auto
start : Manual start of server if not launched
restart : Manual restart of server if started or not
killpy : force stop of python alm-surveillance, only if hang
pause : pause the checker
resume : resume the checker
maj : do maj
getlog : put logs in folder var for remote sync
showpy : show pylog below ... you may have to refresh until done
showlog : show main log below ... you may have to refresh until done
showstatus : show status below ... you may have to refresh until done
showwarning : show pending email below ... you may have to refresh until done
showpid : show PIDs below ... you may have to refresh until done
nolog : remove log or status below ... you may have to refresh until done
listlog : List all logs below
ping : show pings
email : send what is show below by email and clear it
clearlog : send logs by email and clear logs without showing it
time : sync time
xxxx : other check if all zone ok
refresh : just refresh for log below
help : List all commands
help : repeat last cmd

Current cmd:

logs:
PrgVersion=V 2.13.0
StartTime=1788039244
CMD=STATE-SURVEILLANCE§§§§SEND:LOGFLUSH
Res=State:1
GRes=
End=1
StopTime=1788039244
Surveillance_version=4.21.0
starting check-update (V1.20) 00:11:32:53:e1:d1 for V 2.13.0 Sat Aug 29 23:35:04 CEST 2026

----------------------------------------
nolog : remove log above ... you may have to refresh until done